Mix View or Arrange View?
When it comes to adjusting audio and MIDI routings, the Mix view can sometimes be the most
efficient way to do: The familiar mixing desk layout allows you to quickly find the parameters
you are looking for and adjust the routing on the fly. Hence, in the following sections we de-
scribe  the  procedures  in  both  Arrange  view  and  Mix  view.  For  more  details  on  the  Mix  view,
please refer to chapter ↑12, Controlling Your Mix.
You will also find useful examples of the various routings described here in chapter ↑13, Using
Effects.
Configuring the Audio Routing from Your Controller
All the procedures described in the following sections make use of the Channel properties. As
a consequence, they can also be done from your controller! To do this, switch your controller to
Control mode and navigate to the desired Channel  properties as described in section ↑2.3.9,
Navigating Channel Properties, Plug-ins, and Parameter Pages in the Control Area.
11.1.1 Sending External Audio to Sounds
 
Each Sound  can  be configured  to  receive  external audio  signals.  These  audio  signals  can  be
coming from the following sources:
▪ Outside MASCHINE (from your audio interface if MASCHINE is used in stand-alone mode,
or from your host if MASCHINE is used in plug-in mode).
▪ Additional outputs of multiple-output Plug-ins that might be loaded somewhere else in your
Project.
Each Sound can use one external stereo input. The same external signal can be fed into any
number of Sounds.
For  example,  this  allows  you  to  have  any  external  audio  signal  be  processed  by  the  Plug-ins
loaded in that Sound, and more generally, integrate external audio signals into the MASCHINE
routing and processing system. See also section ↑13.2, Applying Effects to External Audio for
an example of use and step-by-step instructions.
The  configuration  of  external  audio  inputs  for  a  Sound  is  done  on  the  Audio  page  of  the
Sound’s Input properties.
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
 
MASCHINE - Manual - 534