Native Instruments MASCHINE MK3 User Manual

9.1 Bass Synth – General Handling
This section describes the general use and features of the Bass Synth.
Managing the Bass Synth
Bass Synth is a MASCHINE Plug-in and, as such, supports all usual Plug-in actions and proce-
dures. Hence, to know how to load, remove, replace, insert, move, copy/paste a Bass Synth, as
well as how to adjust the Bass Synth parameters, and load/save presets, please refer to section
↑6.1, Plug-in Overview, where these are described in detail.
Bass Synth presets can be loaded from the Browser by selecting: SOUNDS, MASCHINE,
BASS SYNTH.
9.1.1 Parameter Organization
The Bass Synth has the same parameters in both the Control area of the Arrange view and in
the Plug-in Strip of the Mix view.
Parameter Pages in the Control Area (Arrange View)
In Arrange view (Ideas view and Arranger view), the parameters of the Bass Synth are grouped
in the Control area:
Bass Synth parameter organization in the Control area.
▪ The parameters are grouped into two Parameter pages:
Using the Bass Synth
Bass Synth – General Handling
MASCHINE - Manual - 420

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs