Native Instruments MASCHINE MK3 User Manual

Appending a Scene to the Arrangement Using the Controller
Using your controller you can append a Scene to the arrangement.
1. Press SHIFT + SCENE (Section) to enter Ideas view.
2. Press and hold SCENE (Section) to enter Scene mode.
3. Press Button 7 and 8 to select the desired Scene bank.
4. Press Button 3 (APPEND).
5. Press the pad corresponding to the Scene you want to append. You can do this more than
once, tapping a series of pads will add all of those Scenes into Sections at the end of the
Arranger in one quick step.
Release the SCENE (Section) button or turn off APPEND when done.
15.2.12 Naming Scenes
By default, Scenes are named Scene 1, Scene 2, Scene 3, etc. You can rename Scenes and
use custom names of your own. Naming is only available from within the software, but any
changes will also show up on your controller.
Renaming Scenes in the Arranger
To rename a Scene in the Arranger:
1. Double-click the Scene name at the top of the Arranger:
You can also right-click ([Ctrl]-click on macOS) the Scene slot or the corresponding cell in
Working with the Arranger
Using Ideas View
MASCHINE - Manual - 773

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs