Native Instruments MASCHINE MK3 User Manual

Multiple selection is not possible from the controller. Hence, setting the focus to the
previous/next Zone automatically deselects any other Zone, the focused Zone now being
the only selected Zone.
The Sample can be played back on the Cue channel at any time by pressing the corresponding
pad on your controller. When the Sample is played back, the Playhead indicator (vertical line)
shows you the current play position within the waveform on the right display.
For more information on the Cue channel, please refer to section ↑12.2.6, Using the
Cue Bus.
Removing a Zone
► On the ZONE page of Sampling mode, press Button 5 (REMOVE) to remove the focused
Zone from the Sound.
16.5.4 Selecting and Editing Zones in the Map View
The Map view is visible when the Sample View button (showing a little waveform icon at the
right of the Zone tab) is disabled.
Disable the Sample View button to see the Map view.
The Map view contains following elements:
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE - Manual - 867

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs