Native Instruments MASCHINE MK3 User Manual

Parameter Description
Engage Activates the filter.
Frequency Sets the cutoff frequency according to the min/max range
parameters.
FILTER
Type Selects from Low Pass, Band Pass and High Pass modes.
Resonance Sets the resonance of the filter. Values over 100% will lead
to self-oscillation—be careful! Turn down the Output Gain
(and turn up the Saturation to compensate) in order to avoid
extremely loud ringing. Note that the resonance will sound
more pronounced at lower saturation settings and vice versa.
Setup Page
Parameter Description
RANGE Section
Min. Freq Sets the lower limit for cutoff frequency.
Max. Freq Sets the upper limit for cutoff frequency.
SATURATION Section
Saturation Sets the input gain of the filter.
Out Level Sets the output gain of the filter.
14.7.2 Flanger
A comb filter effect with more than a few tricks up its sleeve. Get performance-ready flanger or
phaser effects, or expose its wild side – setting higher decay and frequency values unleashes
ping-pong delay-like flutter effects.
Effect Reference
Perform FX
MASCHINE - Manual - 730

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs