Native Instruments MASCHINE MK3 User Manual

Parameter Description
SR SR stands for “sample rate”: you can use it to lower the original
sample rate in order to make the Sound more lo-fi.
Bits Allows you to lower the original bit depth of the Sound, resulting in a
more rough, digital sounding lo-fi effect.
FILTER
The Filter selector in the FILTER section gives you access to a set of different filters. Using the
arrows or clicking the type currently displayed, you can choose from different filter type set-
tings: Off, LP2, BP2, HP2, and EQ. Each type results in different parameters to the right of it:
Filter Modes Description
Off No filter.
LP2 LP2 is a low-pass filter with Cutoff and Resonance parameters.
Cutoff can be modulated by Velocity, the Modulation Envelope, the
LFO or the MIDI Modulation Wheel.
BP2 BP2 is a band-pass filter with a Cutoff parameter. Cutoff can be
modulated by Velocity, the Modulation Envelope, the LFO or the
MIDI Modulation Wheel.
HP2 HP2 is a high-pass filter with Cutoff and Resonance parameters.
Cutoff can be modulated by Velocity, the Modulation Envelope, the
LFO or the MIDI Modulation Wheel.
EQ The EQ is an equalizer with Frequency, Bandwidth and Gain
parameters.
Working with Plug-ins
The Sampler Plug-in
MASCHINE - Manual - 307

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs