Envelope Controls Description
Decay With Decay you adjust how fast the envelope drops to the sustain
level in ADSR mode; in AHD mode it is used to adjust how fast the
envelope fades out.
Sustain The envelope level that will be maintained as long as the note is
played.
Release The time for the sustain level to return to zero after the note has
ended.
DESTINATION
This is where you define modulation targets for the modulation envelope, i.e. the parameters
you want this envelope to control. The knobs adjust the amount of modulation for the following
targets:
Parameter Modulation Destination
Pitch Tune parameter of the PITCH / GATE section on the Pitch / Envelope
page (page 2).
Cutoff Cutoff parameter of the FILTER section (with filter types LP2, HP2,
BP2 only) on the FX / Filter page (page 3).
Drive Drive parameter of the FX section on the FX / Filter page (page 3).
Pan Pan parameter on the Audio page of the Sound’s Output properties
(see ↑11.1.2, Configuring the Main Output of Sounds and Groups for
more information).
Working with Plug-ins
The Sampler Plug-in
MASCHINE - Manual - 309
To Next Page
Loading...
