The process of using Gate mode is as follows; load an audio loop onto a Sound, select Gate
mode from the control panel of the Audio plug-in and then add MIDI events in the Pattern in
the regions where you want to chop and pitch your audio, or press play on your controller and
use the pads to pitch the audio. For more information on recording and editing events, refer to
chapter ↑10, Working with Patterns.
To zoom into a Pattern, double-click on the vertical scroll bar to the right of the Pattern
Editor.
Using the Audio Plug-in
Using Gate Mode
MASCHINE - Manual - 334
To Next Page
Loading...
