Take Undo
Suppose you have just recorded a 16th-note hi-hat beat over four bars, but then decide to can-
cel it. Normally you would have to cancel the 64 notes one at a time, repeatedly calling the
undo function 64 times in a row. This is what Take Undo has been made for!
Take Undo/Redo is an extended undo/redo available while recording that allows you to cancel
or re-execute a whole group of actions at once.
Take Undo/Redo is the default undo/redo in MASCHINE. In the software use the common key-
board shortcuts for the Undo and Redo functions:
► To cancel your last group of actions, press [Ctrl]+[Z] ([Cmd]+[Z] on macOS). To re-exe-
cute your last group of actions, press [Ctrl]+[Y] ([Cmd]+[Y] on macOS). You can also se-
lect Undo and Redo from the Edit menu in the Application Menu Bar or from the Edit
submenu in the MASCHINE menu.
The commands in the Edit menu additionally shows which action will be undone/redone!
Undo/Redo on the Controller
Both Step Undo and Take Undo are also available on your controller:
1. On the MASCHINE hardware controller, perform the Take Undo operation by pressing
SHIFT + pad 1 (UNDO). To perform the Take Redo operation, press SHIFT + pad 2 (RE-
DO).
2. On the MASCHINE hardware controller, perform the Step Undo operation by pressing
SHIFT + pad 3 (STEP UNDO). To perform the Step Redo operation, press SHIFT + pad 4
(STEP REDO).
Take Undo is available in following situations:
▪ Recording in Control mode
▪ Recording in Step mode
▪ Recording modulation
Outside of these three situations, Take Undo has the same effect as Step Undo (see
above).
Basic Concepts
Common Operations
MASCHINE - Manual - 40
To Next Page
Loading...
Need help?
General
