Native Instruments MASCHINE MK3 User Manual

Element Description
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Tune Hold When Tune Hold is enabled, the tuning behavior is that of the
Fractal tom: the tuning is fixed until the next note is received (see
↑8.5.1, Tom – Tronic). This allows you to create arpeggiated
patterns by adjusting the Tune parameter while a sequence of notes
is playing.
When Tune Hold is disabled (default), the tuning behavior is that of
the other modules: the tuning responds immediately when you
adjust the Tune parameter.
Glide Adjusts the glide between the pitch of new notes, measured in
milliseconds. When the Glide parameter is set higher than zero, the
pitch glides smoothly to the new tuning. The Glide parameter then
defines the duration this glide takes. Available values range from
None (no glide, default) to 762.8 ms.
Impact Adjusts the amount of attack, measured as a percentage. Available
values range from 0.0 % (soft attack) to 100.0 % (maximum
attack). The default value is 60.0 %.
Advanced Page
The Advanced page contains parameters controlling the individual oscillators.
Using the Drumsynths
The Percussions
MASCHINE - Manual - 404

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs