→ The selected Pattern is loaded in the Pattern Editor and its events appear in the Event
area. Furthermore, this Pattern is referenced by a Clip for the selected Group in the cur-
rent Scene in the Arranger. This Clip replaces any previous Clip for the Group in that
Scene (see chapter ↑15.3, Using Arranger View for more on this).
If you want to select a Pattern already referenced by one or more Clips in the Arranger,
you can click any of these Clips to select and load the referenced Pattern in the Pattern
Editor. This way your arrangement won’t be modified.
Selecting Patterns and Pattern Banks on the Controller
To select a Pattern located in another Pattern bank than the one selected, you fist need to se-
lect that other Pattern bank:
► Press PATTERN + Button 7 or 8 to select the previous or next Pattern bank.
If the last Pattern bank is selected and not empty, pressing Button 8 will create a new,
empty Pattern bank — see section ↑10.7.5, Creating and Deleting Pattern Banks for
more information.
Selecting a Pattern
► To select a Pattern in the current Pattern bank, press PATTERN + the dim lit pad corre-
sponding to the cell of the desired Pattern on the right display.
→ Selecting a Pattern has the following consequences:
▪ This Pattern is displayed in the software’s Pattern Editor. You can then modify it both from
your controller and in the software.
▪ This Pattern is referenced by a Clip for the selected Group in the current Scene. This Clip
replaces any previous Clip for the Group in that Scene (see chapter ↑15.3, Using Arranger
View for more on this).
If you only want to quickly select another Pattern without using any from the editing
commands available, we recommend you to unpin the Pattern mode so you can quickly
use the shortcut PATTERN + pad to select the desired Pattern.
Working with Patterns
Managing Patterns
MASCHINE - Manual - 505
To Next Page
Loading...
Need help?
General
