Element Action
Knob: Click the knob and drag your mouse vertically to change
the parameter value. Hold [Shift] on your computer keyboard and
drag your mouse to adjust the value in finer increments.
Button: Click the button to switch its state. When the button is
enabled, it shows a small colored LED.
Selector: Click the displayed value to open the drop-down list,
and click another value in the list to select it.
Navigating Channel Properties, Plug-ins, and Parameter Pages using the Controller
On the controller, do the following:
1. Set the focus on the desired Sound, Group or the Master (see section ↑2.3.7, Focusing on
a Group or a Sound).
2. At the top left of your controller, press the CHANNEL button to display the Channel prop-
erties or the PLUG-IN button to display the Plug-in slots of the selected Sound, Group or
the Master.
3. Press Button 1 (MASTER), Button 2 (GROUP) or Button 3 (SOUND) to display the Plug-
ins and Channel properties of the Master, the focused Group or the focused Sound, re-
spectively.
4. Use the 4-D encoder or press Button 5/6 to navigate the Channel properties or Plug-ins
(the name of the selected Channel properties or Plug-in appears between the left and
right arrows under Button 5 and 6).
Upon your selection the parameters of the selected Channel properties or Plug-in are
shown on the displays of your controller.
Basic Concepts
Common Operations
MASCHINE - Manual - 51
To Next Page
Need help?
General
