5. Turn Knob 1 to set the SOURCE to Ext. 1.
→ Now the external audio is routed to your Sound! You can adjust the level of the incoming
signal by turning Knob 2 (GAIN).
Method 2: Using the Navigate Page
1. Press Button 5 repeatedly until the Input properties are selected (you should see INPUT
at the top left of the right display, under Button 5/6).
2. Press SHIFT + NAVIGATE + pad 1 to select the Audio Parameter page. You can also press
the Page Left button until it turns off, since the Audio page is the first page of the Input
properties.
You will now see two parameters at the bottom of the left display: SOURCE (which selects
the source) and GAIN (which adjusts the level of the input).
3. Turn Knob 1 to set the SOURCE to Ext. 1.
Using Effects
Applying Effects to External Audio
MASCHINE - Manual - 645
To Next Page
Loading...
