Native Instruments MASCHINE MK3 User Manual

◦ If Retrigger is disabled (default setting), the next Section that is selected will play
from the same offset to the beginning of the Section: e.g., leaving the current Section
on beat 3 will cause the new Section to start playing on its beat 3. This ensures that
the global groove of your track is not interrupted!
15.1.3.1 Jumping to Other Sections in the MASCHINE Software
In the software, the Perform Grid and the Retrigger setting can be adjusted in the MASCHINE
Header:
Adjusting the Perform Grid and Retrigger setting.
► To adjust the Perform Grid, click the value left of the SYNC label in the MASCHINE
Header and select the desired division from the menu:
→ The next time you select a new Section or group of Sections for looping, the switch will
happen on the next division selected here.
► To enable/disable the Retrigger setting, click the little cog wheel in the MASCHINE Head-
er and select Retrigger from the menu.
Working with the Arranger
Arranger Basics
MASCHINE - Manual - 756

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs