→ The Scene name is now highlighted to indicate that this Scene is selected.
Once a Scene Has Been Selected…
Once you have selected a Scene, the following happens:
▪ The selected Patterns slots for the focused Scene are highlighted. The Pattern slot with a
white frame is displayed in the Pattern Editor. Unselected Pattern slots are dimmed. If
there are no Patterns slots select for the Scene in focus, or if there are no Patterns at all,
the Pattern Editor is empty.
▪ If playback is off the playhead immediately jumps to the beginning of the selected Scene.
If playback is on the playhead jumps according to the Perform Grid settings.
Selecting Scenes and Scene Banks on the Controller
Selecting a Scene Bank
To select a Scene located in another Scene bank than the one currently selected, you fist need
to select that other Scene bank:
1. Press SHIFT + SCENE (Section) to enter Ideas view.
2. Press SCENE (Section) + Button 7 or 8 to select the previous or next Scene bank, respec-
tively.
If the last Scene bank is selected and not empty, pressing Button 8 will create a new,
empty Pattern bank — see section ↑15.2.6, Creating and Deleting Scene Banks for
more information.
Selecting a Scene
To select a Scene in the current Scene bank:
1. Press SHIFT + SCENE (Section) to enter Ideas view.
2. Press SCENE (Section) + the dim lit pad corresponding to the cell of the desired Scene
on the right display. Alternatively you can press SCENE + Page buttons to select the pre-
vious/next Scene.
Upon your selection, the following happens:
Working with the Arranger
Using Ideas View
MASCHINE - Manual - 765
To Next Page
Loading...
Need help?
General
