Mouse/Keyboard Action Command
Hold [Ctrl] ([Cmd] on macOS) and
click several Zones
Selects all clicked Zones. Click a selected Zone to
deselect it (i.e. remove it from the selection).
Hold [Shift] and click two Zones Selects both Zones and all Zones in-between.
Click and drag a selection frame in
the Sample Map
Selects all Zones within or overlapping the frame.
Press [Ctrl]+[A] ([Cmd]+[A] on
macOS)
Selects/deselects all Zones. When deselecting, only
the focused Zone remains selected.
Edit Commands
Drag the left/right border of a Zone Adjusts the key range for the selected Zones.
Drag the higher/lower border of a
Zone
Adjusts the velocity range for the selected Zones.
Drag a corner of a Zone Simultaneously adjusts the lowest/highest note and
the lowest/highest velocity of the selected Zone(s) —
depending on the corner.
Click inside a Zone and drag Moves the selected Zone(s) across the Sample Map.
Note that the Root Key of each Zone is moved
accordingly.
Double-click a Zone Extends the key and velocity ranges of the Zone so
that it fits the key and velocity limits of the neighbor
Zones. This can be very useful to quickly fill up any
key or velocity gap between Zones.
Right-click ([Cmd]-click on macOS) a
Zone
Opens the Sample Map menu (see below).
Press [Del] or [Backspace] Removes the selected Zone(s) from the Sample Map.
You can also adjust the key and velocity ranges in the Zone settings at the bottom of the
Zone page. See ↑16.5.6, Adjusting the Zone Settings for a detailed description.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE - Manual - 870
To Next Page
Loading...
Need help?
General
