Virtual Private Networking Using IPSec Connections
262
ProSecure Unified Threat Management (UTM) Appliance
c. Specify the settings that are explained in the following table.
8. Configure the global parameters:
a. Click Global Parameters in the left column of the Configuration Panel screen. The
Global Parameters pane displays in the Configuration Panel screen.
Table 61. VPN client advanced authentication settings
Setting Description
Advanced features
Aggressive Mode Select this check box to enable aggressive mode as the mode of negotiation
with the UTM.
NAT-T Select Automatic from the drop-down list to enable the VPN client and UTM
to negotiate NAT-T.
Local and Remote ID
Local ID As the type of ID, select DNS from the Local ID drop-down list because you
specified FQDN in the UTM configuration.
As the value of the ID, enter utm_remote.com as the local ID for the VPN
client.
Note: The remote ID on the UTM is the local ID on the VPN client. It might
be less confusing to configure an FQDN such as client.com as the remote ID
on the UTM and then enter client.com as the local ID on the VPN client.
Remote ID As the type of ID, select DNS from the Remote ID drop-down list because
you specified an FQDN in the UTM configuration.
As the value of the ID, enter utm_local.com as the remote ID for the UTM.
Note: The local ID on the UTM is the remote ID on the VPN client. It might
be less confusing to configure an FQDN such as router.com as the local ID
on the UTM and then enter router.com as the remote ID on the VPN client.
To Next Page
Loading...
Need help?
General