Virtual Private Networking Using IPSec Connections
268
ProSecure Unified Threat Management (UTM) Appliance
Figure 161.
3. Specify the settings that are explained in the following table.
Table 64. VPN client IPSec configuration settings
Setting Description
VPN Client address Either enter 0.0.0.0 as the IP address, or enter a virtual IP address that is used by
the VPN client in the UTM’s LAN; the computer (for which the VPN client opened a
tunnel) appears in the LAN with this IP address.
Address Type Select Subnet address from the drop-down list. This selection defines which
addresses the VPN client can communicate with after the VPN tunnel is
established.
Remote LAN address Enter 192.168.1.0 as the remote IP address (that is, LAN network address) of the
gateway that opens the VPN tunnel.
Subnet mask Enter 255.255.255.0 as the remote subnet mask of the gateway that opens the VPN
tunnel.
To Next Page
Loading...
Need help?
General