Virtual Private Networking Using IPSec Connections
269
ProSecure Unified Threat Management (UTM) Appliance
4. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
Configure the Global Parameters
 To specify the global parameters:
1. Click Global Parameters in the left column of the Configuration Panel screen. The
Global Parameters pane displays in the Configuration Panel screen.
Figure 162.
2. Specify the default lifetimes in seconds:
ESP Encryption Select 3DES as the encryption algorithm from the drop-down list.
Authentication Select SHA-1 as the authentication algorithm from the drop-down
list.
Mode Select Tunnel as the encapsulation mode from the drop-down list.
PFS and Group Select the PFS check box, and then select the DH2 (1024) key group from the
drop-down list.
Note: On the UTM, this key group is referred to as Diffie-Hellman Group 2 (1024
bit).
Table 64. VPN client IPSec configuration settings (continued)
Setting Description
To Next Page
Loading...
Need help?
General