Virtual Private Networking Using SSL Connections
345
ProSecure Unified Threat Management (UTM) Appliance
 To define the client IP address range:
1. Select VPN > SSL VPN > SSL VPN Client. The SSL VPN Client screen displays:
Figure 210.
2. Select the check box and complete the fields as explained in the following table:
Table 90. SSL VPN Client screen settings
Setting Description
Client IP Address Range
Enable Full Tunnel Support Select this check box to enable full-tunnel support. If you leave this check
box cleared (which is the default setting), full-tunnel support is disabled but
split-tunnel support is enabled, and you need to add client routes (see Add
Routes for VPN Tunnel Clients on page 346).
Note: When full-tunnel support is enabled, client routes are not operable.
DNS Suffix A DNS suffix to be appended to incomplete DNS search strings. This setting
is optional.
Primary DNS Server The IP address of the primary DNS server that is assigned to the VPN tunnel
clients. This setting is optional.
Note: If you do not assign a DNS server, the DNS settings remain
unchanged in the VPN client after a VPN tunnel has been established.
Secondary DNS Server The IP address of the secondary DNS server that is assigned to the VPN
tunnel clients. This setting is optional.
To Next Page
Loading...
Need help?
General