Monitoring System Access and Performance
467
ProSecure Unified Threat Management (UTM) Appliance
IP Address The IP address of the WAN port.
These settings are either obtained
dynamically from your ISP or
specified by you on the WAN ISP
Settings screen for this port (see
Manually Configure the Internet
Connection on page 70).
Subnet Mask The subnet mask of the WAN port.
Gateway The IP address of the gateway.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS Server The IP address of the secondary DNS server.
MAC Address The default MAC address for the port or the MAC address that you have specified on
the WAN Advanced Options screen for the port. For information about configuring the
MAC address, see Configure Advanced WAN Options on page 89.
Wireless information in SLOT-1 Info or SLOT-2 Info
Note: For the UTM9S only: Wireless information is shown in the SLOT-1 Info or SLOT-2 Info section, depending
on the slot in which the wireless module is installed.
The following fields are shown for the wireless module:
Card Type This is a fixed field that states Wireless.
Daughter Card This is a fixed field that states Wireless.
Firmware Version This is a fixed field that states N/A. This field might show a software version in a future
release.
SSID The SSID of the wireless access point that you have specified on the Edit Profile
screen. For information about configuring the SSID, see Configure and Enable
Wireless Security Profiles on page 553.
Security Type The type of wireless security and encryption that you have specified on the Edit Profile
screen. For information about configuring wireless security, see Wireless Data Security
Options on page 549 and Wireless Security Profile on page 551.
Country The region and country that you have specified
on the Radio Settings screen.
For information about configuring the
basic wireless radio settings, see
Configure the Basic Radio Settings on
page 546.
Operating Frequency The operating frequency that you have
specified on the Radio Settings screen:
2.4 GHz or 5 GHz.
Advanced Wireless
Network Mode
The wireless mode that you have specified on
the Radio Settings screen.
Channel The channel or automatic channel selection
that you have specified on the Radio Settings
screen.
IP Address The IP address of the default WLAN that is specified on the LAN Setup screen. For
information about how to change the default WLAN IP address, see Configure a VLAN
Profile on page 96.
MAC Address The MAC address for the wireless access point is a fixed address that is assigned to
the wireless module.
Table 121. Detailed Status screen fields (continued)
Item Description
To Next Page
Loading...
Need help?
General