Oki CX2731MFP - Page 245

245 – Issues: Error Messages
MC361/MC561/CX2731 MFP Advanced User’s Guide
Belt Unit Near
Life
Please see Help
for details
Lights up* The belt unit is near the end
of its life.
Prepare a replacement belt
unit.
*If the <SETTING> key >
[Admin Setup] >
[Management] > [System
setup] > [Status in Near life]
is set to [Enable] and [Near
life LED] is set to [Disable],
the <STATUS> key does not
turn on.
If [Status in Near life] is set to
[Disable], this message is not
displayed and the <STATUS>
key does not turn on.
354 Please change
Fuser Unit: 354
Please see Help
for details
Blinks The fuser unit is at the end of
its life. This error indicates the
end of its life according to the
counter, and the current job is
stopped.
Replace it with a new fuser
unit.
Please change
Fuser Unit
Please see Help
for details
Lights up The fuser unit is at the end of
its life.
Replace it with a new fuser
unit.
355 Please change
Belt Unit: 355
Please see Help
for details
Blinks The belt unit is at the end of
its life. This error indicates the
end of its life according to the
counter, and the current job is
stopped.
Replace it with a new belt
unit.
Code Message
<STATUS>
key
Cause/Remedy