306
– MFP Memory: SD Memory Card
MC361/MC561/CX2731 MFP Advanced User’s Guide
Initial Lock is enabled. Before you can initialize the SD card, you
must first change the Initial Lock setting to disabled.
To enter the [Admin Setup] menu, an administrator password is
required. The default password is “aaaaaa”.
An SD memory card should be initialized before use when it has been
used in another machine or if it is not properly recognized when it is
installed in the MFP.
An SD memory card has three partitions. They are PS, Common, and
PCL. You can either reformat the whole SD card or you can format
particular partitions individually.
Formatting the Entire SD Card
Important!
When you reformat an entire SD memory card, the following
data is deleted:
• SData stored using [Secure Print], [Encrypted Secure
Print], or [Store to SD Card]
• Font data
• Custom demo data
To reformat the entire SD card:
1 Press the <SETTING> key on the control panel.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
4 Use the arrow keys to select [Enter], then press <OK>.
5 Press the down arrow key to select [Management], then press
<OK>.
6 Disable the Initial Lock:
a) Press the down arrow key to select [Storage Maintenance
Setup], then press <OK>.
b) Press the down arrow key to select [Initial Lock], the press
<OK>.
To Next Page
Loading...
Need help?
General
