311
– MFP Memory: Resetting to Defaults
MC361/MC561/CX2731 MFP Advanced User’s Guide
g) Press the down arrow key to select [Initial Lock], the press
<OK>.
h) Press the down arrow key to select [Enable], then press
<OK>.
9 Press the left arrow key to go back up to the main screen.
Resetting to Defaults __________
You can return the configured settings to their default.
Important!
When you initialize the equipment settings, the following
data is deleted:
• Stored documents on the Fcode bulletin board
• Fax jobs that have not been sent
• Received fax jobs in secure boxes
• Registered job macros
• Dialing logs
• E-mail logs
1 Press the <SETTING> key on the control panel.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
4 Use the arrow keys to select [Enter], then press <OK>.
5 Press the down arrow key to select [Management], then press
<OK>.
6 Press the down arrow key to select [Reset Settings], then press
<OK>.
7 Make sure that [Execute] is selected, then press <OK>
8 A confirmation message appears. Select [Yes] to continue.
(Select [No] to cancel.)
The MFP restarts.
To Previous Page
Loading...
Need help?
General
