55
– Faxing: Fax Reception Settings
MC361/MC561/CX2731 MFP Advanced User’s Guide
Note
• When the excess part is larger than the specified reduction
margin, the excess part is printed on the next page.
• When the excess part is smaller than the specified reduction
margin, the received image is reduced onto a single page.
• When you set [Rx Reduc. Rate] to [100%] and the excess part is
smaller than the specified reduction margin, the excess part is
discarded.
Changing the Buzzer Volume
To change the volume of the buzzer which sounds when there is an
incoming fax or call:
1 Press the <SETTING> key.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
4 Use the arrow keys to select [Enter], then press <OK>.
5 Press the down arrow key to select [Management], then press
<OK>.
6 Press the down arrow key to select [Sound Control], then press
<OK>.
7 Press the down arrow key to select [Buzzer Volume], then press
<OK>.
8 Press the down arrow key to select a volume, then press <OK>.
9 Use the left arrow key to go back to the main screen.
To Next Page
Loading...
Need help?
General
