56
– Faxing: Fax Reception Settings
MC361/MC561/CX2731 MFP Advanced User’s Guide
Note
The buzzer volume can only be set when [Fax Reception Mode]
is set to [Phone / Fax Standby].
Automatically Forwarding Faxes
You can set the MFP to automatically forward received faxes to a
specified destination. To do this, set the fax [Forwarding Setting] to
[ON.
Notes
When fax forward is enabled, received faxes are not printed by
the MFP.
Setting Up Fax Forward
1 Press the <SETTING> key.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
4 Use the arrow keys to select [Enter], then press <OK>.
5 Press the down arrow key to select [Fax Setup], then press
<OK>.
6 Press the down arrow key to select [Fax Basic Settings], then
press <OK>.
7 Press the down arrow key to select [Forwarding Setting], then
press <OK>.
8 Press the down arrow key to select [ON], then press <OK>.
9 Press the left arrow key to go up a level.
To Next Page
Loading...
Need help?
General
