36
– Faxing: Transmission Functions
MC361/MC561/CX2731 MFP Advanced User’s Guide
Manual Redialing
To redial manually, specify the desired destination from the
transmission history.
Note
For details on the transmission history, see the Basic User’s
Guide on the DVD supplied with your MFP.
Transmission in Real Time
By factory default, the scanned fax data is stored in memory before
the MFP starts transmission. This is called memory transmission. In
this mode, you do not have to wait for the MFP to finish transmission.
When you disable memory transmission, the fax data is scanned and
transmitted instantly. This allows you to check that the fax is
transmitted to its destination. This is called real time transmission.
Important!
• You can scan only a single page when using the document
glass for real time transmission.
• While you are sending a fax using real time transmission,
other jobs using the ADF and document glass cannot be
done.
To enable real time transmission:
1 Press the <FAX> key.
2 Make sure that [Fax] is selected and press <OK> to open the fax
standby screen.
3 Press the down arrow key to select [Fax Functions], then press
<OK>.
4 Press the down arrow key to select [Memory Tx], then press
<OK>.
5 Press the down arrow key to select [OFF], then press <OK>.
To Next Page
Loading...
Need help?
General
