53
– Faxing: Fax Reception Settings
MC361/MC561/CX2731 MFP Advanced User’s Guide
4 Use the arrow keys to select [Enter], then press <OK>.
A screen that requires you to re-enter the destination number
appears.
5 Enter the destination number again using the numeric keypad.
6 Use the arrow keys to select [Enter], then press <OK>.
The fax standby screen appears.
7 Press the <Mono Start> key to start transmission.
Fax Reception Settings ________
Reducing Received Images Larger than
the Paper Size
Note
To enter the [Admin Setup] menu, the administrator password
is necessary. The default password is “aaaaaa”.
Parts of images that do not fit in the printable area of the specified
paper size may be reduced, discarded, or printed on the next sheet
of paper. For example, if an A4 size image is received and the
specified paper size is letter, the bottom of the image is printed on
the next sheet of paper.
You can avoid this situation by specifying a reduction rate and
margin.
Specifying a Reduction Rate
Your MFP is set by default to automatically reduce received images to
fit on the selected paper size: [Rx Reduc. Rate] is set to [Auto]. To
change this setting to eliminate auto reduction:
1 Press the <SETTING> key.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
To Next Page
Loading...
Need help?
General
