19
– Copying: Copying Identification Cards
MC361/MC561/CX2731 MFP Advanced User’s Guide
Copying Identification Cards ____
This function allows you to copy both sides of an ID card, such as a
driver’s license, onto one side of a piece of paper.
Notes
• Works only with the document glass. You cannot use the ADF for
this function.
• Place the card so that the top of it is on the upper-left corner of
the document glass, leaving a 2 mm scan margin.
• The MFP scans an area half the size of the specified paper. If the
document is more than half the size of the paper size, the
excess part is discarded.
1 Press the <COPY> key.
2 Press the right arrow key to enter the [Change settings] menu.
3 Press the down arrow key to select [ID Card Copy], then press
<OK>.
4 Press the down arrow key to select [ON], then press <OK>.
5 Press the left arrow key Eruptively to go back to the copy
standby screen.
6 Place the card face down on the document glass.
7 Use the numeric keypad to enter the number of copies.
8 Press the Mono Start or Color Start key.
9 When the [Set the back side.] screen appears, turn the card over
so that the back is face down on the document glass.
10 Press the down arrow key to select [Start scanning], then press
<OK>.
To Next Page
Loading...
Need help?
General
