30
– Faxing: Sender Name (TTI)
MC361/MC561/CX2731 MFP Advanced User’s Guide
5 Press the down arrow key to select [ON], then press <OK>.
6 Press the left arrow key until the fax standby screen appears.
7 Place your document with text face up in the ADF or face down
on the document glass.
8 Specify a destination.
9 Press the <Mono Start> key.
10 When the [Set next document.] screen appears, place the next
document with text face up in the ADF or face down on the
document glass.
11 Press the down arrow key to select [Scan next page], then press
<OK>.
12 Repeat steps 10 and 11 as necessary for each document you
want to fax.
13 When all the documents are all scanned, press the down arrow
key to select [Start Sending], then press <OK>.
Note
For details on how to stop scanning and to cancel transmission,
refer to the Basic User’s Guide on thee DVD supplied with your
MFP.
Sender Name (TTI) ___________
You can specify the sender name to be printed on faxes you send.
You must register a Sender Name in advance.
Note
Make sure that [Sender Name] is enabled before using the
following functions. For details, see the Setup Guide supplied
with your MFP.
To Next Page
Loading...
