38
– Faxing: Transmission Functions
MC361/MC561/CX2731 MFP Advanced User’s Guide
3 Place your document with text face up in the ADF or face down
on the document glass.
4 Configure the fax functions if necessary.
5 When you hear a dial tone, press the <Mono Start> key to start
the transmission.
6 Put down the handset.
When the transmission is complete, the MFP returns to the screen
displayed before the manual transmission.
Transmit to Multiple Destinations
This function, known as Broadcast, allows you to transmit faxes to
multiple destinations at the same time. You can specify up to 100
destinations using the ten-key pad, speed dial, and group lists of
destinations.
1 Place your document with text face up in the ADF or face down
on the document glass.
2 Press the <FAX> key.
3 Make sure that [Fax] is selected and press <OK> to open the fax
standby screen.
4 Make sure that [Add destination] is selected, then press <OK>.
5 Specify a destination.
6 Repeat steps 5 to enter all the destinations.
7 When you have specified all the destinations, press the <Mono
Start> key.
Note
• To cancel the operation, press the <RESET/LOGOUT> key.
• When [Check broadcast dest.] is enabled, the destination
numbers are displayed before transmission.
To Next Page
Loading...
Need help?
General
