269
– Issues: Unable to Print
MC361/MC561/CX2731 MFP Advanced User’s Guide
For Windows
Network Connection Problems
Common to Windows and Macintosh
Cause Remedy
The MFP is not set as the
default printer.
Set the MFP as the default printer.
The output port for the
printer driver is incorrect.
Select the output port to which the
Ethernet or USB cable is connected.
A print job from another
interface is in progress.
Wait until the print job is done.
[Received invalid data] is
displayed on the display
screen and printing cannot
be done.
Press the <SETTING> key and select
[Admin Setup] > [Print Setup] > [Print
menu] > [Printer Adjust] > [Wait
Timeout], and then select a longer time.
The default setting is 40 seconds.
A print job is automatically
canceled.
If using Print Job Control, the print job is
not authorized to print, or the Job
Accounting log buffer may be full.
Cause Remedy
Using a crossover cable. Use a straight cable.
The MFP is turned on
before a cable was
connected.
Connect cables before turning on the MFP.
The hub and the MFP are
incompatible or have some
problem.
Press the <SETTING> key and select
[Admin Setup] > [Network Menu] >
[Network Setup] > [HUB Link Setting], and
then select [10BASE-T HALF].
To Next Page
Loading...
Need help?
General
