45
– Faxing: Fcode Transmission
MC361/MC561/CX2731 MFP Advanced User’s Guide
10 Press the up arrow key to select [Add destination], then press
<OK>.
11 Specify a destination.
12 Press the <Mono Start> key.
Fcode Polling Using a Sub Address
You can perform Fcode polling by entering the sub address of a
sender MFP’s bulletin box. This function makes a remote fax MFP
transmit a fax in response to instructions from your MFP.
Note
You cannot receive data if the sender has a password on the
bulletin box.
1 Press the <FAX> key.
2 Make sure that [Fax] is selected and press <OK> to open the fax
standby screen.
3 Press the down arrow key to select [Fax Functions], then press
<OK>.
4 Press the down arrow key to select [Fcode Polling], then press
<OK>.
5 Press the down arrow key to select [ON], then press <OK>.
6 Enter the sub address of the bulletin box registered in the sender
MFP.
7 Use the arrow keys to select [Enter], then press <OK>.
8 Press the left arrow key to go back to the start screen.
9 Press the up arrow key to select [Add Destination], then press
<OK>.
10 Specify a destination.
11 Press the <Mono Start> key.
To Next Page
Loading...
Need help?
General
