Oki MC860 - Page 306

Oki Data CONFIDENTIAL
43967002TH Rev. 1
306 /
7. Troubleshooting
Error Code
Displayed message Descriptions
460 %TRAY% Media
Mismatch.
On %TRAY%
Please set
paper(%MEDIA_SIZE%
%MEDIA_TYPE%).
To cancel
Select [Cancel]
The size of paper or media type in the tray does not
match the print data.
Load paper that was set in %MEDIA_SIZE% and
%MEDIA_TYPE% in tray.
%TRAY%
MPTray
Paper size displays in Custom mode:
"<width>x<length><unit>"
ex.) 210x297MM
8.5x11.0INCH
The unit of paper size in Custom: The unit specified for
MPTray (menu setting) is used if no unit is specified by
the driver. When the driver specifies a unit, the unit is
used for display.
461
462
463
%TRAY% Media
Mismatch.
On %TRAY%
Please set
paper(%MEDIA_SIZE%
%MEDIA_TYPE%).
To cancel
Select [Cancel]
The media type in the tray and the print data do not
match.
Load paper that was set in %MEDIA_SIZE% and
%MEDIA_TYPE% in tray.
%TRAY%
Tray1
Tray2
Tray3
Paper size displays in Custom mode:
"<width>x<length><unit>"
ex.) 210x297MM
8.5x11.0INCH
The unit of paper size in Custom: The unit specified for
MPTray (menu setting) is used if no unit is specified by
the driver. When the driver specifies a unit, the unit is
used for display.
Error Code
Displayed message Descriptions
461
462
463
%TRAY% Media
Mismatch.
On %TRAY%
Please set
paper(%MEDIA_SIZE%
%MEDIA_TYPE%).
To cancel
Select [Cancel]
The size of paper or media type in the tray does not
match the print data.
Load paper that was set in %MEDIA_SIZE% and
%MEDIA_TYPE% in tray.
(It takes a while until the status disappears after you
have closed the tray and the lever lifted.)
%TRAY%
Tray1
Tray2
Tray3
Paper size displays in Custom mode:
"<width>x<length><unit>"
ex.) 210x297MM
8.5x11.0INCH
The unit of paper size in Custom: The unit specified for
MPTray (menu setting) is used if no unit is specified by
the driver. When the driver specifies a unit, the unit is
used for display.
490 No Paper
On %TRAY%
Please set paper
(%MEDIA_SIZE%).
To cancel
Select [Cancel]
Printing request is issued to an empty MPTray.
Load paper that was set in %MEDIA_SIZE%.
%TRAY%
MPTray
The unit of paper size in Custom: The unit specified for
MPTray (menu setting) is used if no unit is specified by
the driver. When the driver specifies a unit, the unit is
used for display.
This error is occurred, when the MPTray is in the home
position and the sensor "PE SNS2" cannot detect
papers.