Olympus FLUOVIEW FV300 - Page 168

APPLIED OPERATIONS/Image Acquisition
IV. OPERATION INSTRUCTIONS
IV . 2-54
Page
4 Setting the interval time
1. From the page tabs on the bottom right of the [Acquire] panel, select the [Time
Series] sub-panel. A panel as shown below will be displayed.
2. Set the interval time using the <
> or <
> button in the [Interval] text box.
An image with no interval can be acquired by entering [0] in the [Interval]
text box.
In this case, the [Interval] text box shows “Free Run” message.
Using <
> button also sets the [Interval] text box to “Free Run”.
5 Setting the number of scans
1. Set the number of scans using the <
> or <
> button in the [N] text box in the
[Time Series] sub-panel.
Fig. 2-17 [Time Series] Sub-panel
TIP
[N] text box
Set the number of scans using the
<
> or <
> button or by input
from the keyboard. Under text box,
it displays max. number of slices
that can be acquired with use o
f
physical memory only available at
that time.
[Interval] text box
Set the interval time using the <
>
or <
> button or by input from the
keyboard.
[Total Time] text box
Shows the total time required fo
r
image acquisitions.
[Rest Time] text box
Shows the time after end o
f
acquisition of an image until the
start of next acquisition.