APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-55
Page
6 Acquiring image
1. Click the <XYZT> button in the [Acquire] panel.
The acquired image will be displayed in the [Live] panel.
When the built-in power supply for transmitted light illumination is used for a long
period in the XYZT mode, the metallic parts may be expanded by heat, causing the
focusing to be deviated. To acquire precise image data, it is recommended to turn
off the power of the transmitted light.
While acquiring an image in the XYZT observation mode, clicking the <STOP SCAN>
button changes the buttons at the upper part of the [Acquire] panel as shown below. The
<Resume> button restarts image acquisition at the frame next to the frame where the
acquisition is suspended.
<Resume> button
Restarts image acquisition at
the frame next to the frame
where the acquisition is
suspended.
<Series Done> button
Determines the acquired
images. Once this button is
clicked, it is not possible to
append an image.
To Next Page
Loading...
