APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-75
Page
3. [Group] (which means each laser) and the <
> and <
> buttons appear on the
lower part of each [CH] group box.
4. Set the group number according to the reagent in use with the <
> and <
>
buttons. This setting is not required if the desired number is already displayed.
Image acquisition starts with the smallest group number set.
To prevent unwanted color fading, it is recommended to acquire the
image from the reagents with longer wavelengths.
5. Click the <Seq. Once> button to acquire the image.
6. When transmitted light observation is required, the [FLUOVIEW] dialog box and
[Lasers] sub-panel are displayed to allow you select the laser type which has not
been specified yet.
Fig. 2-22 [FLUOVIEW] Dialog Box
Click to increase
the acquired group
Click to decrease
the acquired group
Shows the group to
be acquired.
TIP
NOTE
To Next Page
Loading...
