Olympus FLUOVIEW FV300 - Page 211

APPLIED OPERATIONS/Image Acquisition
IV. OPERATION INSTRUCTIONS
IV . 2-97
Page
6. In order to adjust the laser intensity for every region, right-click the mouse on the
white region on the [Display] panel where the REX mask file is displayed. The pop-
up menu as shown below appears.
7. Select [Set intensity] in the menu.
The [Mask Intensity] dialog box as shown below appears.
8. Set the value for the laser intensity on percentage and click the <Accept> button.
The brightness of the region is changed according to the value set in the [Mask
Intensity] dialog box.
The laser intensity of the REX mask file is setup on percentage to 100%.
The region becomes brighter as the value is close to “100”.
In case of using REX function, setting of [Laser Intensity] in [Laser]
sub-panel is recommended to set 100%. Otherwise, the actual laser
intensity may not be reproducable since the [Laser Intensity] setting
affects as followings.
Actual laser intensity = (laser intensity in [Laser Intensity] group box)
x (Percentage in the [Laser Intensity] dialog box)
<Accept> button
A
ccepts the value set in the
[Laser Intensity] text box and
closes the dialog box.
<Cancel> button
Cancels the value set in the [Lase
r
Intensity] dialog box and closes
the dialog box.
TIP
TIP
NOTE
NOTE