APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-100
Page
4 Selecting REX Mask File and Setting the Laser ON/OFF
Set the REX mask file in the REX mode and Bleach mode, and the laser ON/OFF
respectively.
1. Select the [REX mode] option button in the [AOTF] group box in the [Lasers] sub-
panel.
2. A frame to specify the REX mask file appears on the right side of the [REX mode]
option button. Right-click the mouse inside the frame to display the pop-up menu as
shown below.
Select the image to be masked in the menu.
In order to use the already saved file as a REX mask file, open the image
beforehand.
The opening method of the REX mask file is completely the same as that of
an image. For details, refer to section 2-3-2, “Opening Previously Saved
Images” in this manual.
3. The icon of the selected REX mask file is displayed inside the frame.
The icon of the selected
REX mask file is displayed
inside the frame. And the
file name and the
observation mode are also
displayed above and under
the frame.
[REX mode] option
button
TIP
To Next Page
Loading...
