APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-101
Page
4. Select the [Bleach mode] option button in the [AOTF] group box of the [Laser] sub-
panel.
5. A frame to specify the REX mask file appears on the right side of the [Bleach mode]
option button. Right-click the mouse inside the frame to display the pop-up menu as
shown below.
Select the image to be masked in the menu.
In order to use the already saved file as a REX mask file, open the image
beforehand.
The opening method of the REX mask file is completely the same as that of
an image. For details, refer to section 2-3-2, “Opening Previously Saved
Images” in this manual.
6. The icon of the selected REX mask file is displayed inside the frame.
7. Set each laser ON/OFF, and their intensity.
If necessary, use the [Laser Intensity] dialog box in the [Lasers] sub-panel to set the
laser ON/OFF.
And the value set in the [Laser Intensity] dialog box can be obtained apart from the
value set in the Disable/REX mode.
The REX mask file displayed
in the [Display] panel is pop-
up displayed.
The icon of the selected
REX mask file is displayed
inside the frame. And the
file name and the
observation mode are also
displayed above and under
the frame.
TIP
To Next Page
Loading...
