APPLIED OPERATIONS/Protocol processor
IV.
OPERATION INSTRUCTIONS
IV .
2-155
Page
Pan Status: Enter Pan value, refer to [Pan] [Zoom]group box in [Acquire] panel.
FLUOVIEW software [Pan][Zoom] Group Box
Pan value can not enter the following condition.
· Mode is set to any of XY, XYT, XYZ or XYZT.
· SubMode is Normal.
· Zoom is set to 1 (1.0 x).
Variables are available in [For] statement for X Pan and Y Pan.
In addition, four-rule calculation is possible.
For details about how to use variables, see One Point of 2-4-8 “2䇭Example
of Setting Procedure of XYT Observation for hours (Protocol using
repetition processing)”.
Angle: Assign rotated image scan angle of field of view. 0 through 359 can be entered.
Angle can not set at a certain sub scan mode, and a certain hardware. Please
see 2-4-10 [Restrictions at [PAPP] window input time]. for entered angle value
restriction.
Variables are available in [For] statement for Angle setting.
In addition, four-rule calculation is possible.
For details about how to use variables, see One Point of 2-4-8 “2䇭Example
of Setting Procedure of XYT Observation for hours (Protocol using
repetition processing)”.
Sub Mode: Sub Mode is for scan mode setting of New mode appears by click on Mode
area. A certain scan mode may not set because of hardware configuration.
See 2-4-10 “Restrictions at [PAPP] window input time” for restriction of scan
X Pan, Y Pan Angle
Zoom
TIP
TIP
TIP
To Next Page
Loading...
