APPLIED OPERATIONS/ Protocol processor
IV.
OPERATION INSTRUCTIONS
IV .
2-156
Page
mode setting.
In this case of Normal scan, there might be scanned before the scan mode
changes.
Scan Status: Change scanning position and its size with the selected scan mode. See
2-4-10 “Restrictions at [PAPP] window input time” for restriction of Scan
status input.
Variables are available in [For] statement for X Pos, Y Pos, X Size, Y Sieze.
In addition, four rule calculation is possible.
For details about how to use variables, see One Point of 2-4-8 “2䇭Example
of Setting Procedure of XYT Observation for hours (Protocol using
repetition processing)”.
Scan speed: 㪪㪼㫋㫊 image acquisition speed from “Fast”, “Middle”, “Slow” and “Init” in the
㫇㫌㫃㫃㪄㪻㫆㫎㫅 menu.
The above speed is the same with those of [Scan Speed] group box in
[Acquire] panel. In case that [Fast] or [Fast Clip] is selected in [Sub mode],
[Scan Speed] is automatically set to [High Speed].
Laser Intensity: Enter the intensity setting for each laser. The setting is 0 to 100, and the
unit is %. When it sets to 0, a laser shutter is closed.
REX Mask: Select the REX mask file from the pull-down list whether to use the REX
Examples of parameters: Default clip scan
position setting which appears when the clip
scan is selected with 512 x 512 pixel.
· X Pos : 256
· Y Pos : 256
· X Size : 256
· Y Size : 256
TIP
㩿㪇㪃㩷㪇㪀 㩿㪌㪈㪈㪃㩷㪇㪀
㩿㪌㪈㪈㪃㩷㪌㪈㪈㪀㩿㪇㪃㩷㪌㪈㪈㪀
㩷 㩷 㪰㩷㪧㫆㫊㩷 㩷 㪉㪌㪍
㪯㩷㪧㫆㫊
㪉㪌㪍
㪯㩷㪪㫀㫑㪼
㪉㪌㪍
㪰㩷㪪㫀㫑㪼
㪉㪌㪍
To Next Page
Loading...
