APPLIED OPERATIONS/Image Processing
IV.
OPERATION INSTRUCTIONS
IV .
2-234
Page
4. When the image was acquired in the multi-channel mode, select whether the LUT
intensity mapping (re-assignment) is applied to multiple channels simultaneously or
to a single channel.
To select the target channel(s), use the <Display channel switch> buttons. The
histogram of the selected channel(s) is displayed.
Example) When only the Ch1 image is displayed, the histogram of Ch1 is displayed
and mapping of only the Ch1 image is possible.
For the switching of channels, see section 2-4-3, “Switching the Display
Channels”.
5. Click the <Compute Histogram> button. A histogram as shown in Fig. 2-89
appears.
Fig. 2-89 Histgram
<Display channel switch>
buttons
TIP
To Next Page
Loading...
