APPLIED OPERATIONS/Image Processing
IV.
OPERATION INSTRUCTIONS
IV .
2-235
Page
6. Enclose the histogram section of interest using the scale in the [Master View] field.
7. The magnified view of the region selected by the scale is shown in the [Selected
View] field.
Fig. 2-90 Histogram of the Selected Region
8. When the image was acquired in the multi-channel mode, select the channel(s) to
be subjected to LUT intensity mapping (re-assignment) using the [Channel] option
buttons.
9. Select the region to be subjected to mapping (re-assignment) using the scale in the
[Selected View] field. While moving the scale, confirm the change in contrast in the
[Display] panel. The intensity values in the selected region are mapped (re-
assigned) to intensity values from 0 to 255 and displayed.
The vertical chart axis
represents the degree and
the horizontal axis
represents the mapped
intensity values.
To Next Page
Loading...
