Olympus FLUOVIEW FV300 - Page 545

Software Setup/Adding the dyeing method
V . MAINTENANCE
V. 1-25
Page
3. Click [Edit Dye Assign Database] button.
[Optical System Configuration Setup] dialog box appears as shown below.
4. In the list box in the [Dye Select] group box, select the dyeing method to be
changed or created (CFP in this example). When a dyeing method is selected and
if there is information associated with the selected dyeing method, the [Excitation
DM] drop-down list shows the excitation dichroic mirrors, the [Beam Splitter] drop-
down list shows the beam splitters, the [Barrier Filter] drop-down list shows the
barrier filters, the [Dye] drop-down list shows the dyeing methods and the [Laser]
group box shows the set laser types, all on the per-channel basis.
To select more than one dyeing method, select the required methods while
holding the Ctrl key.
[TD Unit] group box
Displayed when the transmitted light
unit is installed.
The channel No. is displayed
together with ”Transmitted”.
[Dyes] drop-down list
Select the dyeing method
detected in each channel.
Select the blank when the
selection is not required.
[Laser]
Shows the lasers set
for the channels.
[Dye Select] group box
The valid dyeing methods (those for
which the laser wavelengths are
defined) defined in the database
(Probedb.mdb) are displayed.
Clicking the <Clear Selection> button
clears the dyeing method selection in
the list box.
[Excitation DM] drop-down list
Select the excitation dichroic mirror
for each channel.
[Beam Splitter] drop-down list
Select the beam splitter for each channel.
Select the blank when the selection is not
required.
[Barrier Filter] drop-down
list
Select the barrier filter for
each channel.
Select the blank when the
selection is not required.
Channel numbers.
TIP