Olympus FLUOVIEW FV300 - Page 546

Software Setup/Adding the dyeing method
V . MAINTENANCE
V. 1-26
Page
Associations between dyeing methods and detection channels are saved
per dyeing method combination, and applied when the combination is
selected in the [Dyes] sub-panel of the FLUOVIEW software.
Associations between dyeing methods and filters are saved per dyeing
method combination, and displayed as setting guide on [Microscope
configuration] window when the said combination is selected in the [Dyes]
sub-panel of the FLUOVIEW software.
5. To change the excitation dichroic mirror, use the [Excitation DM] drop-down list.
When it is not required to specify excitation dichroic mirror, select the blank.
In this example, select ”DM488/515”.
6. To change the beam splitter, use the [Beam Splitter] drop-down list.
When it is not required to specify a beam splitter mirror, select the blank.
In this example, select “Mirror” for Channel 1.
7. To change the barrier filter, use the [Barrier Filter] drop-down list.
When it is not required to specify a barrier filter, select the blank.
In this example, select “BA480-495” for channel 1.
8. To change the dyeing method detection channel, set the [Dye] drop-down list of the
previous channel to blank and select the dyeing method in the [Dye] drop-down list
for the new channel.When it is not required to specify the detection channel, select
TIP
TIP