Omron SYSMAC FH Series User Manual

WWW.NNC.IR
Macro Reference
482
Vision System FH/FZ5 Series
User’s Manual (Z340)
Example
Uses the *MEASUREDISPG subroutine of the Unit Macro processing unit to display the ellipse whose radii in
the X and Y directions are the measured coordinates of the center of gravity by the labeling processing unit
(Processing Unit number 5). In this example, set the judgement conditions for the labeling processing unit to
"Gravity X", "Gravity Y", "Elliptic major axis", and "Elliptic minor axis" from label number 0. Therefore, the
assigned external reference data numbers to the gravity X, gravity Y, elliptic major axis, and elliptic minor axis
parameters are 1000, 1100, 1200, and 1300 respectively.
To display the string at the fixed position regardless of the position compensation result, specify the assigned
processing unit number to this Unit Macro processing unit (where the *MEASUREDISPG subroutine is used)
for the <unitNo> parameter.
Useable Modules
Unit macro
Supported Versions
Version 3.50 or later
Related Items
*MEASUREDISPG
Rem Get the measurement result.
GetUnitData 5, 1000, X#
GetUnitData 5, 1100, Y#
GetUnitData 5, 1200, XDIAMETER#
GetUnitData 5, 1300, YDIAMETER#
Rem Draw the image
DrawEllipse Int(X#), Int(Y#), Int(XDIAMETER# / 2), Int(YDIAMETER# / 2), 0, UnitNo
Return
GetUnitData (Reference: X Details (p.552)) Int (Reference: X Details (p.575))
SetDrawStyle (Reference: X Details (p.700)) UnitData (Reference: X Details (p.778))
UnitNo (Reference: X Details (p.790)) Ut (Reference: X Details (p.793))

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English