Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 100 -
reading, writing, etc.
+CPMS: <used1>,<total1>,<used2>,<total2>,<used3>,<total3>
OK
If error is related to ME functionality:
ERROR
[<mem1>
,<mem2>
,<mem3>]
Parameters
<mem1> Messages to be read and deleted from this memory
storage
"SM" SIM message storage
<mem2> Messages will be written and sent to this memory
storage
"SM" SIM message storage
<mem3> Received messages will be placed in this memory
storage if routing to PC is not set ("+CNMI")
"SM" SIM message storage
<usedx> integer type;Number of messages currently in <memx>
<totalx> integer type;Number of messages storable in <memx>
Reference
GSM 07.05
Note
4.2.11 AT+CRES Restore SMS Settings
AT+CRES Restore SMS Settings
Test Command
AT+CRES=?
Response
+CRES: (list of supported <profile>s)
OK
Response
TA restores SMS settings from non-volatile memory to active memory. A
TA can contain several profiles of settings. Settings specified in commands
Service Centre Address +CSCA, Set Message Parameters +CSMP and
Select Cell Broadcast Message Types +CSCB (if implemented) are restored.
Certain settings may not be supported by the storage (e.g. SIM SMS
parameters) and therefore can not be restored.
OK
If error is related to ME functionality:
ERROR
Write Command
AT+CRES=[<pr
ofile>]
Parameter
<profile>
0 manufacturer specific profile number where setting are
to be stored
Reference Note
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English