M10 AT Commands Set
M10_ATC_V1.01 - 82 -
Response
OK
+CME ERROR: <err>
Write Command
AT+CCWE=[<m
ode>]
Parameter
<mode>
0 Disable call meter warning event
1 Enable call meter warning event
Unsolicited result codes supported:
+CCWV Shortly before the ACM (Accumulated Call Meter)
maximum
value is reached, an unsolicited result code +CCWV will
be
Approximately when 5 seconds call time remains. It is
also issued when starting a call if less than 5 s call time
remains.
Parameters
Reference
GSM 07.07 [13]
Note
GSM 07.07 specifies 30 seconds, so Quectel deviate from the
specification.
3.2.57 AT+CBC Battery Charge
AT+CBC Battery Charge
Response
+CBC: (list of supported < bcs >s),(list of supported < bcl >s),(voltage)
OK
Test Command
AT+CBC=?
Parameters
see Execution Command
Response
+CBC: < bcs >, < bcl >,<voltage>
OK
+CME ERROR: <err>
Execution
Command
AT+CBC
Parameters
<bcs> charge status
0 ME is not charging
1 ME is charging
2 Charging has finished
<bcl> battery connection level
1...100 battery has 1-100 percent of capacity remaining
vent
<voltage> battery voltage(mV)
To Next Page
Loading...
