Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 113 -
+CGEV: NW DEACT <PDP_type>, <PDP_addr>[,<cid>]
+CGEV: ME DEACT <PDP_type>, <PDP_addr>[,<cid>]
+CGEV: NW DETACH
+CGEV: ME CLASS <class>
parameters
<PDP_type> Packet Data Protocol type (see +CGDCONT Command)
<PDP_addr> Packet Data Protocol address (see +CGDCONT
Command)
<cid> Context Id (see +CGDCONT Command)
<class> GPRS mobile class (see +CGCLASS Command)
Reference
GSM07.07
Note
5.2.10 AT+CGREG Network Registration Status
AT+CGREG Network Registration Status
Test Command
AT+CGREG=?
Response
+CGREG: (list of supported <n>s)
OK
Parameter
See Write Command
Read Command
AT+CGREG?
Response
+CGREG: <n>,<stat>[,<lac>,<ci>]
OK
+CME ERROR: <err>
Parameter
See Write Command
Write Command
AT+CGREG=[<
n>]
Response
OK
ERROR
Parameters
<n> 0 disable network registration unsolicited result code
1 enable network registration unsolicited result code
+CGREG:<stat>
2 enable network registration and location information
unsolicited result code +CGREG: <stat>[,<lac>,<ci>]
<stat>
0 not registered, ME is not currently searching a new
operator to register to
1 registered
<lac> string type; two byte location area code in hexadecimal format
(e.g. “00C3” equals 195 in decimal)
<ci> string type; two bytes cell ID in hexadecimal format
Quectel